Optik cutaway

[MrHixxx 0]

I put together a simple cutaway design for the chin cup on my Optik. It is a bit derivative of others and a bit mine. It is spring load that fires the spindle out of the helmet when the cotter is pulled, the parts are gone, but they are cheap.

safe skies, Jon

death,as men call him, ends what they call men
-but beauty is more now than dying’s when

[PhreeZone 15]

Instead of using a clovis pin have you tried using a cotter pin? I had a Clovis until it started getting soft with its tension after about 5 practice cutaways. Also ho far does that stick out from the side of the helmet?

Yesterday is history
And tomorrow is a mystery

Parachutemanuals.com

[MrHixxx 0]

I looked at the cotter, but was a little concerned about the softer metal wearing through from tension. The spring I used is all the way down, so there is a decent amount of tension there.

The assembly itself only sticks out as far as the audible pocket. I am going to look into have an alluminum cap machined to replace the nylon spacer and washer which are glued together. The spacer is there to keep a line from snagging the spring.

-Jon

death,as men call him, ends what they call men
-but beauty is more now than dying’s when

[leroydb 0]

nice... maybe you could package that adn sell it?

Leroy


..I knew I was an unwanted baby when I saw my bath toys were a toaster and a radio...

[skychic68 0]

howdy,

I saw your neat cutaway job in your Optik. What is the recipe for this? How well does it function?

Thanks for any infor you can give me.

Que sera sera

[Craig 0]

There is a similar system Here which is the same type of setup as Phreezone's except I didn't have room for my "handle" closer like his cause my audible pocket was in the way listed Here. It works pretty darn good.

[MrHixxx 0]

I put together a more explanitary diagram for skychic68 for those who are interested...

-Hixxx

death,as men call him, ends what they call men
-but beauty is more now than dying’s when