GoneCodFishing 23 #1 August 17, 2016 Need a little help here. Anyone knows how PA measure the lines for the trim specs (where from/to) and what loads they apply for HMA? Need to reline a canopy, and despite a few e-mails going as far back as January i still had no reply from them. I tested a couple of lines and the measured length does not differ between applying 15 and 25 lbs, so the load seems right without having to go any higher, however the measured length of the 'old' lines seems to be 1cm shorter than trim spec in all of them... Any ideas? Quote Share this post Link to post Share on other sites
parachutist 1 #2 August 18, 2016 GoneCodFishing 1cm shorter than trim spec in all of them... What size is the canopy? Quote Share this post Link to post Share on other sites
GoneCodFishing 23 #3 August 18, 2016 It's a nitron 135 Quote Share this post Link to post Share on other sites
parachutist 1 #4 August 18, 2016 GoneCodFishingIt's a nitron 135 1CM difference if they're all the same amount and direction (all longer or all shorter) will not matter on that canopy. That CM could be a different link used for your measurements vs their Quote Share this post Link to post Share on other sites