A skydiver at the Oklahoma Skydiving Center pointing out their landing pattern. Image by Corey Miller
When we teach students how to skydive, the lessons do not just stop after the first jump course. One important skill all skydivers need to know is how to navigate through the landing pattern. I have heard instructors refer to talking to students on the radio as “remote controlled skydiving” because they guide the student where they want them to land, and they tell the student every turn to make. If we are supposed to teach our students how to pilot their canopy, then we must ask ourselves, “How is this enabling the student to learn?” In this article I will discuss a method of teaching the student how to pilot their canopy that is not only easy to use, but also allows the instructor on the radio to remain in control if the student needs additional guidance while descending under canopy.
Teaching the student piloting skills starts in the classroom. Of course we teach the students the SOPs and to make sure they have a canopy that is Square, Stable, and Steerable; but now what? Do we just give directions to the student over the radio? Realistically, for the student who just opened their canopy for the first time we, as instructors, will probably have to do that. The student has emotions of excitement and fear going through their mind while adrenaline is going through their body. This mixture can make anyone confused, so don’t be surprised if the first time in the landing pattern you are flying a “remote controlled skydiver”. Having said that, let’s discuss how we are going to teach the student to navigate the pattern and eventually, be removed from radio status. I like to start this process with a laminated picture of the landing area and a grease pencil.
With a laminated picture the instructor should sit down with the student and first, have the student draw an arrow showing the direction of the wind. Now we know that the student is aware of the wind direction and we do not have to assume that they do. Next, have the student point out where their “playground” is going to be. For those who do not use the term “playground” that is the area where the student can fly their canopy, while they are descending to the proper altitude to enter the landing pattern. Next, have the student make a mark showing where they will enter the downwind part of the landing pattern and at what altitude this is supposed happen. This is the time the instructor can discuss at what altitude to leave the playground and to start thinking about the landing procedures they covered during the first jump course. Additionally, let the student know that next time things could be different due to wind direction and speed. Next have the student show where, and at what altitude, to make their turn for the base leg of the landing pattern.
Since an aerial picture of the drop zone is be used, the instructor can point out hazards and landmarks at this point. For me, I like to point out a grass runway at the drop zone and to tell students not to go pass it figuring it is better for them to have to walk back a little bit than to risk getting too close to the hanger or the active taxiway. Finally, have the student show where, and at what altitude, the final turn would be.
At this point the instructor should reiterate the importance of the wind sock, what altitude to stop turns and to do only small corrections, and of course, when to flare. Since the student is making marks on a laminated picture, it is a good training aid to keep and to use when debriefing the student after the jump. The instructor can point out how the plan and the actual landing pattern were different. The instructor then can talk about how safety could have been affected and discuss a plan for improvement. After the debriefing the student, just wipe the photo clean and use it for the next student. Now, let’s talk about our first jump student some more.
When teaching a first jump student, I do not advocate going through all of this in great detail on their first jump. Instead, have them look at the picture. Ask them about where they would want to be at 1,000 feet. Where would they turn for the base leg and final leg of the landing pattern? If we, as instructors, get into too much detail for the first jump the student can have a sensation overload and forget everything. Additionally, a sensation overload could make the experience less enjoyable and possibly hinder the chances for repeat business and some good word of mouth advertising. By just showing them what will be happening we can reduce the student’s anxiety by reducing their fear of the unknown. Additionally, if there should be a radio failure while the student is under canopy, having shown them on a photo of the landing zone and discussed where they should be in relationship to various ground features we have just increased the chances for the student to land safely.
Author Bio:
Corey Miller is a C rated skydiver who held both coach and IAD instructor ratings. He holds a Master in Aeronautic Science degree with specialties in Teaching and Human Factors. He currently works as an Instructor/Quality Assurance Inspector in the Aerospace Industry. He calls the Oklahoma Skydiving Center his home DZ.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.