0
OmriMon

Takin cameye apart

Recommended Posts

I just got a craft knife and cut off the excess I didnt want. This left the base in the bottom plastic and then I had the button free to play with.

Only thing og note is that the button is conical, smaller at the tip than at the base. Therefore the hole has to be slightly larger than you imagine or it impedes the movement of the button up and dow.

Other than that get a knife and go for it.........

Bryn
Journey not destination.....

Share this post


Link to post
Share on other sites
Personally, I had no problem with the large hole. I just drilled a 5/8" (I think) hole, cleaned up the edges and popped the cameye through. The rubber ring gave a great seal, I didn't need to use any adhesive. It looks great and it's probably easier to find when the time comes to turn on the camera. I just put the liner back in the helmet and it was ready to go. Except for the led. I had to put a 3" piece of copper wire on the end to give it some rigidity. Shrink tubing around that worked great.
$0.02

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

0