ger00039 0 #1 October 30, 2016 I'd like to mount a Bonehead Quick Release on a Z1Evo. Any important hints? Quote Share this post Link to post Share on other sites
angryelf 0 #2 October 30, 2016 I can't find a picture of the helmet, but I'm assuming that it has a curved top. I put a Skysystems mount on a Gath years ago by building up the top of the helmet with JB Weld 2 part epoxy a bit at a time, then sanding a flat surface, carefully drilling mount holes and bolting the mount through the epoxy. I still have that helmet, haven't used it since 2011, but the mount is still firmly on... Another option would be the Cookie flat mount that (I think) is built in conjunction with Trunk at Hypoxic. Another option would be to get some sheet Aluminum (14ga or so) and cut, drill and fold something the meet your needs. Haven't done this: but you might experiment with 3D printing or fiberglass to get what you want. -Harry"Sometimes you eat the bar, and well-sometimes the bar eats you..." Quote Share this post Link to post Share on other sites
ger00039 0 #3 October 31, 2016 Thanks a lot, Harry, I'll do my best ... Aki Quote Share this post Link to post Share on other sites