0
repcool

Engraving a closing pin?

Recommended Posts

I really debated where to post this, but the issue is mostly about the size of a closing pin.

I am taking 30 closing pins with me to a jump I am going to do in the Himalayas from 30,000 feet. It is a special jump to me and I want to get the pins engraved for the friends and family that have supported me. I took them to a few places that do corporate engraving but the size put them off. Any thoughts?


Simon

Share this post


Link to post
Share on other sites
Got a easy solution for you: have it Lazer etched !
I have seen demos on these machines and they can etch a logo on anything, cell phones, knife blades etc. Some stuff like Scuba Gear I work on has SNs and other graphics etched on by Lazer. If you are around any manufacturing trade shows someone always has a demo machine there. (they cost about 20K so you cant really buy one) Finding one to do a batch probably wouldnt be hard, check the net.
Etch per pin would take about 10 sec.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account. It's free!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
0